[AMP] [Alternate] Control4 Driver Download

Overview

Contracted by Just Add Power.

Controls 3G and MaxColor Just Add Power devices setup by AMP Multicast.

Requires Just Add Power justOS firmware B2.1.0 or greater (applied by AMP).

Switching driver supports up to 64 inputs and 64 outputs.

Also includes endpoint control driver and documentation.

Matrix Control v2.07

avswitch_ip_JustAddPower_multicast_32x32.c4z
- Matrix control - switch any display to watch any source
- Maximum of 32 inputs and 32 outputs. Works for any project with less than that.
- Load only 1 into the system (this or the 64x64, not both)
avswitch_ip_JustAddPower_multicast_64x64.c4z
- Matrix control - switch any display to watch any source
- Maximum 64 inputs and 64 outputs. Works for any project with less than that.
- Load only 1 into the system (this or the 32x32, not both)

Endpoint & Feature Control v3.02

proxy_ip_JustAddPower_TerminalServer.c4z
- Endpoint control - control a display or source with RS232, IR, or CEC
- Feature control - control Just Add Power features like video wall or Tiling Transmitter layouts
- Load 1 per Receiver and 1 per Transmitter that needs Endpoint or Device control

Endpoint and Feature Control driver
- Add an IR Output
- Add support for MaxColor IR
Matrix Control driver
- adds more detailed Operational Mode information
- Adds compatibility with OS 2.10.6
- Removes DISCONNECT_OUTPUT response (was setting to channel 0 when a room was turned off)