MaxColor Transmitters and Receivers have a native IR output. The IR output is always enabled.
MaxColor devices must be on firmware MAX V3.7.1 or later
Early productions of MaxColor - QC sticker May 2022 or earlier - have a hardware limitation that prevents IR from working. Please reach out to Support if you have a MaxColor piece that was manufactured in May 2022 or earlier and need to use IR.
MaxColor supports both stereo and mono IR emitters.
IR emitter not included.
IR is enabled by default. In general, IR follows Global Cache standards for IR transmission
To send IR commands to a MaxColor device:
\r
sendir,1:1,1,38000,1,1,127,63,16,16,16,48,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,48,16,16,16,1000\r
When sending IR through a control system that supports IR, follow the instructions for the driver.