The update to OS3 has required the driver file type to change from .c4i to .c4z. Updating from the .c4i version to the .c4z version cannot be done through the Update Driver option in Composer. Instead, the new version must be loaded separately and reprogrammed with the settings from the old driver.
If the update to OS3 causes the Operational Mode to report as "Connecting..." follow these steps to remedy it:
Ensure you are running driver v2.10 or later. v2.09 had corner cases where the driver would not properly reconnect after the switch or processor rebooted.
Go to Connections --> Network. Disconnect the IP and re-enter the IP from the switching driver.
Go to System Design and select the switching driver. Remove the license key, click Set, re-enter the license key, and click Set again.
Reboot the Director if Steps 1-3 did not restore the Operational Mode to Licensed. This will restore the driver to a functional state.
Various sizes are available - 32x32, 64x64, 64x128, 128x128. Larger drivers can cause Composer to crash if the virtual matrix does not have enough available memory. These driver sizes represent maximum sizing and will support any smaller system.
proxy_ip_JustAddPower_TerminalServer.c4i - Just Add Power Serial over IP and Layer 3 driver v2.15
Behaves like a display in Composer with HDMI input, serial output, and CEC power on and off commands
License keys removed!
Driver checks for the presence of Just Add Power hardware for authorization
Username/password entry in the switching driver does not always update properly. Power cycle the Control4 processor to fix permanently.