JADConfig Software Download [v3.4.30.0]

Download button

JADConfig is the free software tool used when setting up a new 2G or 3G Just Add Power installation. JADConfig will configure the managed network switch, assign IP addresses to all Just Add Power devices, and then update all Just Add Power device firmware in the system to a matching version.

Details on how to run JADConfig can be found in the JADConfig Quick Start Guide available on this Knowledge Base. Please be sure the review the requirements outlined in the Quick Start Guide before you begin. A comprehensive step-by-step manual is also available in the JADConfig User Guide, also available on this Knowledge Base.

If you run into any issues while running JADConfig, please refer first to the Troubleshooting section of the JADConfig Quick Start Guide for simple solutions to the most common problems encountered during the configuration process. If you are still having issues after reviewing the Troubleshooting section, please contact Just Add Power Support for further assistance.

JADConfig v3.4.30.0 - new additions in RED

Support for Luxul switches:

AMS-1208P
AMS-2600
AMS-2616P
AMS-2624P
AMS-4424P (stacked or unstacked)
XMS-2624P
XMS-5248P
XMS-7048P (stacked or unstacked)

Support for Cisco switches:

SG300
SG500 (stacked or unstacked)
SG500X (stacked)

Newest Just Add Power firmware:

2G - A6.4.12
3G - A6.4.12

Support for Just Add Power hardware:

208A
208POE
218A
218POE
218AVP
408A
408POE
418A
418POE
418AVP
439A
449A
459A
505POE
508POE
515PoE
518AVP
705POE
707POE
715POE
716VGA
717HIFI
717WP2
718AVP
718WP4
749AVP
IRD

Changes:

  • Add support for 515PoE and 715PoE - 2GΩ/3G+ devices compatible with both 2G and 3G systems
  • Firmware A6.4.12 allows a 2GΩ or 3G device to be put into 2G mode to send/receive video with 2G devices. This mode requires a reboot and has the effect of turning the 3G device into a 2G device.

U110314.12F8

  • 69
  • 20-Mar-2017
  • 4996 Views