JADConfig is the free software tool used when setting up a new 2G or 3G Just Add Power installation. JADConfig will configure the managed network switch, assign IP addresses to all Just Add Power devices, and then update all Just Add Power device firmware in the system to a matching version.
Details on how to run JADConfig can be found in the JADConfig Instructions available on this Knowledge Base. Please be sure the review the requirements outlined in the Instructions before you begin.
If you run into any issues while running JADConfig, please refer first to the Troubleshooting section of the JADConfig Quick Start Guide for simple solutions to the most common problems encountered during the configuration process. If you are still having issues after reviewing the Troubleshooting section, please contact Just Add Power Support for further assistance.
JADConfig v126.96.36.199 - new additions in RED
Support for Luxul switches:
AMS-4424P (stacked or unstacked)
XMS-7048P (stacked or unstacked)
Support for Cisco switches:
SG500 (stacked or unstacked)
Newest Just Add Power firmware:
2G - A6.5.0
3G - A6.5.0
Support for Just Add Power hardware: