Download JADConfig ## Overview JADConfig is a [Windows-only software][1] that will configure a managed Ethernet switch and Just Add Power devices into an HDMI switching matrix. The HDMI matrix uses network infrastructure, but is separate from the main data network; audio/video traffic will not interfere with data tra...
When planning an installation, one of the most important decisions is the managed gigabit Ethernet switch that is the center of the Just Add Power HDMI over IP system. Just Add Power supports 2 switch manufacturers with JADConfig and drivers: Luxul and Cisco. JADConfig will fully configure the switches listed below. ...
* [Stackable Switch Models][1] * [Bandwidth Considerations][2] * [Stacking Cables][3] * * * ## Stackable Switch Models If the [Right Switch][4] for the installation is a stacked switch, then one of these switch models would have been chosen: Switch Model Ports On Max Devices PoE Ports Stacking Bandwidth Max S...
Just Add Power 2G and 3G HDMI over IP matrix switching systems support the Cisco SG300. Video of the full JADConfig procedure for the Cisco SG300 is [available here][1]. [Download JADConfig][2] and follow along with the video to setup your Just Add Power HDMI matrix switching system. [1]: https://www.youtub...
* [Overview][1] * [Download Driver][2] * [Manual][3] * [Versions][4] * [Control4 OS3][5] * [Changes][6] * [[Legacy] Licensed Version][7] * * * ## Overview Controls a [Cisco switch][8] that has been setup with [JADConfig][9]. Requires Just Add Power justOS firmware B2.0.0 or greater. May work on system...
* [Overview][1] * [Download][2] * [Manual][3] * [Versions][4] * [Changes][5] * [[Legacy] Licensed Version][6] * * * ## Overview Controls a [Cisco switch][7] that has been setup with [JADConfig][8]. Switching driver supports up to 200 inputs and 374 outputs and is compatible with all versions of firmware...
* [Overview][1] * [Download][2] * [Versions][3] * [Changes][4] * [[Legacy] Licensed Version][5] * * * ## Overview Controls a [Cisco switch][6] that has been setup with [JADConfig][7]. Requires Just Add Power justOS firmware B2.0.0 or greater. May work on systems with lower firmware, depending on the age o...
Just Add Power has Crestron switching drivers that control HDMI matrix switching on Cisco and Luxul switches. [Download the training video here][1] Cisco * SG300 * SG500 * SG500X Luxul * AMS-1208P * AMS-2600 * AMS-2616P * AMS-4424P * XMS-2624P * XMS-5248P * XMS-7048P [Download the training vid...
Just Add Power 2G and 3G HDMI over IP matrix switching systems support the Cisco SG500 and SG500X in stacked and unstacked setups. Video of the full JADConfig procedure for the Cisco SG300 is [available here][1]. [Download JADConfig][2] and follow along with the video to setup your Just Add Power HDMI matrix switc...
Jumbo Frames are required on switches that are passing 3G video. Luxul switches have Jumbo Frames enabled by default, but they must be enabled on Cisco switches in 3G systems. Running JADConfig will enable Jumbo Frames on Cisco switches. If JADConfig is not being used to update the system: * Use Putty to login to ...