Just Add Power 2G and 3G HDMI over IP matrix switching systems support the Cisco SG500 and SG500X in stacked and unstacked setups. Video of the full JADConfig procedure for the Cisco SG300 is [available here][1]. [Download JADConfig][2] and follow along with the video to setup your Just Add Power HDMI matrix switc...
* [Overview][1] * [Download][2] * [Versions][3] * [Changes][4] * [[Legacy] Licensed Version][5] * * * ## Overview This driver package provides Matrix Control, Endpoint Control, and Feature Control of a Just Add Power VLAN switching system configured with [JADConfig][6]. * Matrix Control - switch any dis...
Jumbo Frames are required on switches that are passing 3G video. Luxul switches have Jumbo Frames enabled by default, but they must be enabled on Cisco switches in 3G systems. Running JADConfig will enable Jumbo Frames on Cisco switches. If JADConfig is not being used to update the system: * Use Putty to login to ...
* [Overview][1] * [Training Video][2] * [Supported Switches][3] * [Luxul][4] * [Netgear][5] * [Cisco][6] * [TP-Link][7] * [Stack vs Trunk][8] * [Bandwidth Considerations][9] * [SFP+ Cables][10] * * * ## Overview If the [Right Switch][11] for a Standardized System (also known as a VLAN S...
* [Overview][1] * [Minimum Switch Firmware][2] * [Walkthrough][3] * * * ## Overview Uploading a switch configuration file might be done for any of these reasons: * Running [AMP][4] and loading the Discovery Configuration file * Copying the configuration from a defective switch into the replacement switch ...
The PDF attached to this Knowledge Base article contains the integration notes from Elan g! for use with the Cisco SG300/SG500 series switches. The driver available in the Elan g! software releases versions 6.4.200 and later include support for the Cisco SG300 series of unstacked switches and Cisco SG500 stacked sw...
* [Overview][1] * [Disable Login][2] * [Re-enable Login][3] * * * ## Overview Not all control systems can navigate a username/password prompt. For those that can't, we can disable the switch login to go straight to the interface. If you are using a [Driver from Just Add Power][4], the switch _**must have logi...
* [Legacy Driver][1] * [Overview][2] * [Download][3] * [Versions][4] * [Changes][5] * * * ## Legacy Driver ### This driver was discontinued ton February 3, 2020 and will no longer be updated. See the [AMX Cisco Driver Package][6] article for the latest version. This driver requires a [License Key][7] to ...
* [Overview][1] * [Walkthrough][2] * * * ## Overview Downloading a switch configuration file might be done for any of these reasons: * Having a backup copy of the switch configuration in case of failure * Copying the configuration from one switch to another * * * ## Walkthrough 1. Login to the switch w...