* [Overview][1] * [Supported Switches][2] * [Luxul][3] * [Cisco][4] * [Discontinued Switches][5] * * * ## Overview JADConfig is no longer being updated. New systems should use [AMP][6] to configure systems, and should use the [Choosing the Right Switch for AMP VLAN article][7] to choose a switch. Wh...
* [Multi-Switch Models][1] * [Stack vs Trunk][2] * [Bandwidth Considerations][3] * [SFP/SFP+ Cables][4] * [Discontinued Switches][5] * * * ## Multi-Switch Models If the [Right Switch][6] for the installation requires multiple switches, then one of these switch models should chosen: Switch Model Ports On M...
Just Add Power 2G and 3G HDMI over IP matrix switching systems support the Cisco SG500 and SG500X in stacked and unstacked setups. Video of the full JADConfig procedure for the Cisco SG300 is [available here][1]. [Download JADConfig][2] and follow along with the video to setup your Just Add Power HDMI matrix switc...
Jumbo Frames are required on switches that are passing 3G video. Luxul switches have Jumbo Frames enabled by default, but they must be enabled on Cisco switches in 3G systems. Running JADConfig will enable Jumbo Frames on Cisco switches. If JADConfig is not being used to update the system: * Use Putty to login to ...
* [Overview][1] * [Affected Versions][2] * [Fix][3] * [via webUI][4] * [via CLI][5] * * * ## Overview Cisco switches at factory default ask the user to change the login username and password on first connection. On older firmware, this process could be bypassed to leave the default settings of cisco/c...
* [Overview][1] * [Disable Login][2] * [Re-enable Login][3] * * * ## Overview Not all control systems can navigate a username/password prompt. For those that can't, we can disable the switch login to go straight to the interface. If you are using a [Driver from Just Add Power][4], the switch _**must have logi...