* [Overview][1] * [Codes][2] * [Docklight Profile][3] * [Notes][4] * * * ## Overview These codes are known to work on 2nd and 3rd Generation Apple TVs All codes sent are in **ASCII** format. IR codes must be terminated with a Carriage Return in order to be sent through Just Add Power devices. * * * ## Cod...
* [Overview][1] * [Codes][2] * [Docklight Profile][3] * [Notes][4] * * * ## Overview These codes are known to work on Sony TVs. All codes sent are in **ASCII** format. IR codes must be terminated with a Carriage Return in order to be sent through Just Add Power devices. * * * ## Codes Command Code (Pront...
* [Overview][1] * [Download][2] * [Build a Driver][3] * [Setup a Driver][4] * * * ## Overview IR control in URC is best accessed by allowing the Accelerate process to build a user interface automatically. In order to do that through the Just Add Power system, standard IR drivers must be converted to IR over ...
The PDF attached to this Knowledge Base article has information on the legacy IR Manager product. _**Note: The IR Manager has been replaced by the new [Flux Capacitor IR Dongle][1].**_ The IR Manager is an RS232 controlled IR learning device with four (4) banks that hold up-to 32 "short" IR commands in each ban...
* [Overview][1] * [Codes][2] * [Docklight Profile][3] * [Notes][4] * * * ## Overview These codes are known to work on Sony Blu-Ray Players. All codes sent are in **ASCII** format. IR codes must be terminated with a Carriage Return in order to be sent through Just Add Power devices. * * * ## Codes Command...
* [Overview][1] * [Requirements][2] * [IR Emitter][3] * [Programming][4] * * * ## Overview MaxColor Transmitters and Receivers have a native IR output. The IR output is always enabled. ![][5] * * * ## Requirements MaxColor devices must be on firmware [MAX V3.7.1 or later][6] Early productions of MaxColo...