You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close

[Legacy] Control4 Cisco Driver requires License Key


Legacy Driver

This driver was discontinued on February 3, 2020 and will no longer be updated.

See the Control4 Cisco Driver Package article for the latest version.

This driver requires a License Key to function. License keys are tied to the mac address of the Control4 processor.


Overview

Controls a Cisco switch that has been setup with JADConfig.

Switching driver supports up to 128 inputs and 128 outputs.

Also includes endpoint control driver and documentation.


Download Driver


Versions

  • avswitch_ip_JustAddPower_CiscoSG300.c4z - Cisco switching driver v2.10
    • Various sizes are available - 32x32, 64x64, 64x128, 128x128. Larger drivers can cause Composer to crash if the virtual matrix does not have enough available memory. These driver sizes represent maximum sizing and will support any smaller system.
  • proxy_ip_JustAddPower_TerminalServer.c4i - Just Add Power Serial over IP and Layer 3 driver
    • Behaves like a display in Composer with HDMI input, serial output, and CEC power on and off commands

Control4 OS3

The update to OS3 has required the driver file type to change from .c4i to .c4z. Updating from the .c4i version to the .c4z version cannot be done through the Update Driver option in Composer. Instead, the new version must be loaded separately and reprogrammed with the settings from the old driver.

If the update to OS3 causes the Operational Mode to report as "Connecting..." follow these steps to remedy it:

  1. Ensure you are running driver v2.10 or later. v2.09 had corner cases where the driver would not properly reconnect after the switch or processor rebooted.
  2. Go to Connections --> Network. Disconnect the IP and re-enter the IP from the switching driver.
  3. Go to System Design and select the switching driver. Remove the license key, click Set, re-enter the license key, and click Set again.
  4. Reboot the Director if Steps 1-3 did not restore the Operational Mode to Licensed. This will restore the driver to a functional state.

Changes

  • Discontinued on February 3, 2020

.c4i Version

The legacy .c4i version of the driver - v2.06 - can be downloaded here.

  • 372
  • 25-May-2021
  • 980 Views