When planning an installation, one of the most important decisions is the managed gigabit Ethernet switch that is the center of the Just Add Power HDMI over IP system.
Just Add Power supports 2 switch manufacturers with JADConfig and drivers: Luxul and Cisco. JADConfig will fully configure the switches listed below.
*If the Right Switch is too large to fit on one switch or there are multiple switch locations, please see the Multi-Switch Considerations article for cable recommendations and bandwidth guidelines for systems with multiple switches.
| Luxul Switch | Ports On | Max Devices | PoE Ports | Multi-Switch, Bandwidth | Ports per Stack Unit |
|---|---|---|---|---|---|
| AMS-1208P | Rear | 9 | 7 | No | N/A |
| AMS-1816P | Rear | 17 | 15 | No | N/A |
| AMS-2600 | Rear | 25 | 0 | No | N/A |
| AMS-2624P | Rear | 25 | 23 | No | N/A |
| XMS-1208P | Front | 9 | 7 | No | N/A |
| XMS-2624P | Front | 25 | 23 | No | N/A |
| SW-510-48P-F | Front | 47 | 47 | No | N/A |
| SW-610-24P-R | Rear | 23 | 23 | Yes, 40Gb | N/A |
| SW-610-48P-F | Front | 47 | 47 | Yes, 40Gb | N/A |
| Cisco Switch | Ports On | Maximum Devices | PoE Ports | Multi-Switch, Bandwidth* | Ports per Stack Unit |
|---|---|---|---|---|---|
| SG350 | Front | 51 | 47 | No | N/A |
| SG550X | Front | 376 | 376 | Yes, 10Gb | 47 |
| The SG350X is not supported at this time. For larger systems needing stacking, use the SG550X. | |||||
The switches listed below are still supported by Just Add Power and JADConfig but are no longer in production by the manufacturer
| Discontinued Model | Maximum Devices | Replacement Model |
|---|---|---|
| Luxul AMS-2616P | 25 | Luxul AMS-2624P |
| Luxul AMS-4424P | 23 | Luxul XMS-7048P or Cisco SG550X for stacked systems Luxul AMS-2624P for single-switch systems |
| Luxul XMS-5248P | 47 | Cisco SG350 |
| Luxul XMS-7048P | 47 | Cisco SG550X |
| Cisco SG300 | 47 | Cisco SG350 |
| Cisco SG500 | 392 | Cisco SG550X |
| Cisco SG500X | 376 | Cisco SG550X |