Connected - Waiting for video source
Message
Connected - waiting for video source
Message Location
In the bottom-left corner of the Diagnostic Screen on a display connected to a Just Add Power Receiver.
Message Meaning
The Receiver is correctly communicating with a Transmitter over the network. However, the Transmitter does not have an active, valid video source.
Solutions
- The source may not be outputting video. Check that the source device is powered on and outputting video.
- The HDMI cable may be bad. Check the HDMI cable between the source and Transmitter.
- The source may be outputting an odd or unsupported resolution. Check that the source device is outputting a resolution that can be handled by the Transmitter.
- The Transmitter may have a defective HDMI port. Swap the Transmitter with a known-working Transmitter and see if the problem follows the Transmitter.
- The switch that the Transmitter and Receiver are connected to is not allowing 1Gbps of traffic between the devices.
- Jumbo Frames are not enabled on the switch in a system with 2GΩ, 3G, or MaxColor devices.
