⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
Build a New AMP System on Multiple Switches - Video
Overview AMP - Advanced Matrix Programmer - is software that configures Omega, Ultra and MaxColor series Just Add Power devices into an HDMI matrix switching system. This video demonstrates building a standardized AV over IP HDMI matrix switching system across multiple supported switches. In a Standardized Confi…
29-May-2025
Stacking vs Trunking for Multi-Switch Systems
Overview Stacking and trunking are different ways to connect multiple network switches. The main difference is how the switches are managed: a stack operates as one logical switch, while trunk-connected switches retain their own configurations and management interfaces. For Just Add Power systems, the configuration…
01-Oct-2026
Convert an Established Omega/Ultra JADConfig Stack-Switch System to AMP
Overview This article explains how to migrate an established Omega Series or Ultra Series system from a JADConfig Luxul switch stack to an AMP Standardized multi-switch configuration. The procedure separates the existing stacked switches, applies an individual AMP discovery configuration to each switch, reconnects …
05-Aug-2026
Multi-Switch Considerations for AMP Standardized Systems
Overview If the Right Switch for a Standardized System (also known as a VLAN Switching System) requires more than one switch, AMP supports up to 63 switches in a single system. Before You Begin: Multi-switch AMP Standardized systems require switches from the same manufacturer, 10Gb SFP+ interconnects, and suff…
01-Oct-2026
Multi-Switch Considerations for JADConfig Systems
Legacy For existing JADConfig systems only. End of Support Notice: JADConfig systems will reach End of Support on January 1, 2027. Migration to AMP will be required before the Just Add Power Support Team can provide further troubleshooting or system service. See JADConfig End of Support Notice for requirements…
31-Jul-2026
