⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
Setup a New System Using a Cisco SG500/SG500X with JADConfig - Video Guide
Legacy For existing JADConfig systems only. End of Support Notice: JADConfig systems will reach End of Support on January 1, 2027. Migration to AMP will be required before the Just Add Power Support Team can provide further troubleshooting or system service. See JADConfig End of Support Notice for requirements…
31-Jul-2026
Build a New AMP System on a Single Switch - Video
Overview AMP - Advanced Matrix Programmer - is software that configures Omega, Ultra and MaxColor series Just Add Power devices into an HDMI matrix switching system. This video demonstrates building a Standardized Configuration AV-over-IP HDMI matrix switching system on a single supported switch. In a Standardiz…
29-May-2025
Setup a New System Using a Cisco SG300 with JADConfig - Video Guide
Legacy For existing JADConfig systems only. End of Support Notice: JADConfig systems will reach End of Support on January 1, 2027. Migration to AMP will be required before the Just Add Power Support Team can provide further troubleshooting or system service. See JADConfig End of Support Notice for requirements…
31-Jul-2026
Build a New System on an Existing Network with AMP Alternate Configuration
Overview Advanced Matrix Programmer (AMP) can configure a new Omega Series, Ultra Series, or MaxColor Series system on an existing managed network using Alternate Configuration . In an Alternate Configuration, AMP configures only the Just Add Power Encoders and Decoders. The Installer or network administrator is r…
18-Aug-2026
