You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.

Showing articles from Auto IP tag

How to Factory Default a Device (Omega, Ultra, and MaxColor Series)

Overview This article outlines the available methods to factory default a Just Add Power Omega (OM), Ultra (UL), and MaxColor (MC) Series device. Minimum Supported Firmware: * Omega (OM) and Ultra (UL) Series: B1.1.0 or newer * MaxColor (MC) Series: MAX v3.5.2 or newer Note: Omega (OM) and Ultra (UL) Series…

section icon

Device Configuration

last updated icon

01-May-2026

factory default reset device Just Add Power Ultra Series Omega Series MaxColor Series Encoders Decoders device reset restore defaults webUI reset Telnet reset debug cable reset PuTTY command line access reset_to_default.sh retain IP full reset network settings Auto IP 169.254.x.x AMP Standardized systems device reconfiguration troubleshooting system recovery firmware requirements

How to Reset to Factory Defaults for 2G Series Devices

Overview This article outlines the available methods to factory default a Just Add Power 2G Series device. Warning: Performing a factory default will immediately erase all configuration settings and reboot the device. This action does not prompt for confirmation. Choosing a Factory Default Method Use the metho…

section icon

2G Series

last updated icon

01-May-2026

factory default 2G Series reset device Just Add Power Encoders Decoders device reset restore defaults webUI reset Telnet reset debug cable reset PuTTY command line access reset_to_default.sh retain IP network settings Auto IP 169.254.x.x system reset device reboot troubleshooting system recovery configuration reset

scroll to top icon