⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
Download - Q-SYS Plugin for AMP Alternate Systems
Overview Contracted by Just Add Power. Controls Ultra Series and MaxColor Series Just Add Power Encoders & Decoders setup as an AMP Alternate system. Please see the full section on Multicast Switching to view how to setup the Just Add Power system to work with the Q-SYS driver. Download Download Q-SYS AM…
08-May-2025
Build a New AMP System on a Single Switch - Video
Overview AMP - Advanced Matrix Programmer - is software that configures Omega, Ultra and MaxColor series Just Add Power devices into an HDMI matrix switching system. This video demonstrates building a Standardized Configuration AV-over-IP HDMI matrix switching system on a single supported switch. In a Standardiz…
29-May-2025
How VLAN Switching Works in AMP Standardized Systems
Overview In an AMP Standardized Configuration, audio and video sources are routed using VLAN Switching. Each Encoder is assigned a dedicated source VLAN. To select a source, the switch changes the VLAN membership of the port connected to the Decoder so that it matches the VLAN assigned to the desired Encoder. Audio…
27-Aug-2026
Upload Switch Config to Cisco CBS350 Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Running AMP and loading the Discovery Configuration file * Copying the configuration from a defective switch into the replacement switch These instructions will fit any of these situations. Minimum Switch Firmware Cisco C…
19-Nov-2024
Download - Control4 Driver for AMP Standardized Systems
Overview This driver package is for Just Add Power Omega, Ultra, and MaxColor systems configured as a Standardized AMP system - through the Let's Go option. The included drivers provide Matrix Control, Endpoint Control, and Feature Control. * Matrix Control - switch any display to watch any source * Endpoint C…
10-Jun-2025
Download - MediaSwitcher4 by Just Add Software
Overview MediaSwitcher4 allows full control of the Just Add Power AV over IP™ HDMI matrix from a permanent on-site Macintosh, Windows or Linux computer. The desktop program pairs with MediaSwitcher4 for iOS to allow control from an Apple tablet. It allows easy and flexible control and provides an instant overv…
28-Apr-2026
Upload Switch Config to TP-Link TL-SG34XX Series
Warning: Maximum Firmware Versions The firmware versions listed below are the maximum supported versions for the specified switch hardware versions. Do not install newer firmware. * SG3428MP V5 : Firmware 5.0.17 V6.20 and V6.26 : Firmware 6.20.16 Build 20251031 V6.30 and V6.36 : Firmware 6.30.0 Bu…
28-Aug-2026
Multi-Switch Considerations for AMP Standardized Systems
Overview If the Right Switch for a Standardized System (also known as a VLAN Switching System) requires more than one switch, AMP supports up to 63 switches in a single system. Before You Begin: Multi-switch AMP Standardized systems require switches from the same manufacturer, 10Gb SFP+ interconnects, and suff…
28-Aug-2026
Just Add Power System Takeover Guide: Identification, Inventory, and Documentation
Overview When servicing an unfamiliar Just Add Power installation, the original system documentation may be unavailable, incomplete, or no longer reflect the equipment currently installed. Before making changes, gather information about the system hardware, switch connections, network settings, firmware, and control…
22-Sep-2026
Supported Switches for AMP Standardized Systems
Overview AMP can build a Standardized Configuration on any supported switch listed in this article. Standardized Configurations are compatible with Just Add Power-provided drivers . When planning a Standardized System, also known as a VLAN Switching System, select a managed gigabit Ethernet switch that can accommo…
28-Aug-2026
