⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
Troubleshoot a 2G Legacy Mode System (2G Legacy Mode)
Overview Use this guide to troubleshoot video, startup, and network connection problems in an established Just Add Power 2G Legacy Mode system. It applies to 2G Series Encoders and Decoders and to compatible Omega Series or Ultra Series devices operating in 2G Mode. Start by identifying whether the problem affects …
01-Oct-2026
2G Legacy Mode Firmware: L1.1.9.0
Overview Firmware L1.1.9.0 enables 2G Series devices and compatible Omega Series and Ultra Series devices to operate under the JPSW switching structure used by AMP 2G Legacy Mode. This is the first L Series firmware release and requires AMP 2.0.0 or later . L Series firmware is intended only for AMP 2G Legac…
02-Oct-2026
Troubleshoot Decoder Diagnostic Screen Messages (Omega, Ultra, and MaxColor Series)
Overview When video is unavailable, a Just Add Power Decoder may display a status message on its Diagnostic Screen. Read the message in the bottom-left corner to find the relevant checks below. Some messages appear briefly during startup, source changes, or device operations. The examples below show a MaxColor Seri…
30-Sep-2026
How to Locate a Device IP Address (Omega, Ultra, and MaxColor Series)
Overview Before accessing a Just Add Power device through the webUI, Telnet, or API, you must first identify its IP address. This article explains several methods for locating the IP address of Omega, Ultra, and MaxColor Series devices. The best method depends on whether the device is part of an existing AMP-standa…
04-Sep-2026
