Add a Device On-Site with AMP - Video
Overview AMP - Advanced Matrix Programmer - is software that configures Omega, Ultra and MaxColor series Just Add Power devices into an HDMI matrix switching system. This video demonstrates adding a device to a Standardized Configuration while on-site. Add Device expects that the switch already has an open port …
29-May-2025
Upload Switch Config to Luxul SW-510 and -610 Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Discovery Configuration file These instructions will fit any of these situations. Minimum Switch Firmware Luxul S…
01-Apr-2025
Upload Switch Config to Cisco Catalyst C1300 Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Running AMP and loading the Discovery Configuration file * Copying the configuration from a defective switch into the replacement switch These instructions will fit any of these situations. Minimum Switch Firmware Cisco C…
19-Nov-2024
Choosing between Standardized and Alternate Configurations
Overview Just Add Power built its reputation for outstanding performance on its design using VLANs, a closed network to distribute audio and video with zero detectable latency. For most installs, a Standardized Configuration using VLAN Switching is the best option for a Just Add Power AV system. For some larger …
14-Nov-2025
Video Guide - Setup Control4 Drivers for AMP Standardized Systems
Overview This video demonstrates importing and configuring drivers for Composer OS3 to control a Just Add Power Standardized System setup with AMP. Download Control4 AMP Standardized drivers here . AMP - Advanced Matrix Programmer - is a software that configures Omega, Ultra and MaxColor Series Just Add Power Enco…
06-May-2025
Build a New AMP System on Multiple Switches - Video
Overview AMP - Advanced Matrix Programmer - is software that configures Omega, Ultra and MaxColor series Just Add Power devices into an HDMI matrix switching system. This video demonstrates building a standardized AV over IP HDMI matrix switching system across multiple supported switches. In a Standardized Confi…
29-May-2025
Download - Control4 Driver for AMP Alternate Systems
Overview Contracted by Just Add Power. Controls Omega, Ultra, and MaxColor Just Add Power devices setup by AMP Alternate . Requires Just Add Power justOS firmware B2.1.0 or greater (applied by AMP). Switching driver supports up to 64 inputs and 64 outputs. Also includes endpoint control driver and documentation…
12-May-2025
Upload Switch Config to Netgear M4250 Series Through Main UI Login
* Overview * Minimum Switch Firmware * Walkthrough Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Final Configuration file These instructions will fit any of t…
19-Oct-2023
IPv4 Address Table for AMP Standardized Systems
Overview Advanced Matrix Programmer uses a unique IP Scheme for all Just Add Power Series devices being setup using the software. Just Add Power Network IP: 172.27.0.0 Just Add Power Subnet Mask: Class B | 255.255.0.0 | /16 The specific subnet does not affect the system as long as 2 rules are followed: * Eac…
25-Sep-2025
Netgear Switch Multicast Profiles
Overview Just Add Power always recommends AMP Standardized systems (VLAN switching) over multicast switching. Netgear switches are supported with Standardized AMP and should allow AMP to configure the switch whenever possible. This article is intended for situations where VLAN switching is not feasible for the pr…
09-Oct-2025
