⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️

Showing articles from DHCP Server tag

Using the Built-In DHCP Server on Just Add Power Decoders

Overview The built-in DHCP Server on a Just Add Power Decoder can provide IP addresses to third-party network devices connected to the Just Add Power Device Network, such as control processors, displays, touch panels, streaming devices, and other network-enabled equipment. For more information about supported conne…

Section: Network Management

Last Updated at
29-Aug-2026

Tags: JADConfig Telnet Static IP DHCP MaxColor Series Ultra Series Omega Series AMP Standardized DHCP Server Decoder DHCP Server Network Configuration Device Network Static Addressing Third-Party Devices Network Access Decoder Switchport
Startup Settings (Omega, Ultra, and MaxColor Series)

Overview Startup settings determine how a device behaves after it boots. These settings are stored in non-volatile memory and remain active after the device is power cycled. This article covers Omega Series, Ultra Series, and MaxColor Series devices running the latest firmware for their series. Before using these…

Section: Device Configuration

Last Updated at
19-Oct-2026

Tags: USB HDR Flux Capacitor Image Pull CLI Command Line RS232 Wallplate Omega astparam HDCP MaxColor Ultra IP Address Device Configuration DHCP Server Device Name Startup Settings Baud Rate Serial Control HDMI Output Debug Screen LED Behavior