⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
How to Identify the Firmware Version of a Device (2G Series and 2G Legacy Mode)
Overview Knowing the firmware version running on your Just Add Power 2G Series Encoders and Decoders is essential when adding new devices, replacing hardware, or verifying compatibility within an existing system. Note: Several methods below require network access to the device. In many installations, this requir…
02-Oct-2026
How to Set Startup Settings (2G Series and 2G Legacy Mode)
Overview Startup settings on a Just Add Power device define how the unit behaves when it powers on. Any changes made to these settings are not applied immediately and will only take effect after the device is rebooted. Many settings are intended for specific installation scenarios and should not be applied as g…
02-Oct-2026
How to Factory Default a Device (2G Series and 2G Legacy Mode)
Overview This article outlines the available methods to factory default a Just Add Power 2G Series device. Warning: Performing a factory default will immediately erase all configuration settings and reboot the device. This action does not prompt for confirmation. Choosing a Factory Default Method Use the metho…
02-Oct-2026
Firmware Update Instructions for 2G Legacy Mode Systems
Overview Follow this [LINK] for instructions on how to perform firmware updates on 2G Series & 2G Legacy Mode-compatible devices.
02-Oct-2026
List of Firmware Versions for 2G Legacy Mode Systems
Overview This article lists firmware versions for Just Add Power 2G Series systems and provides hardware filename references for historical A Series firmware. For systems configured with AMP 2.0.0 or later , AMP applies L Series firmware to 2G Series devices and compatible Omega Series and Ultra Series devices t…
02-Oct-2026
